Product Code:SAE J211/1
Title:Instrumentation for Impact Test - Part 1 - Electronic Instrumentation
Issuing Committee:Safety Test Instrumentation Stds Comm
Scope:This recommended practice outlines a series of performance recommendations, which concern the whole data channel. These recommendations are not subject to any variation and all of them shall be adhered to by any agency conducting tests to this practice. However, the method of demonstrating compliance with the recommendations is flexible and can be adapted to suit the needs of the particular equipment the agency is using.It is not intended that each recommendation be taken in a literal sense, as necessitating a single test to demonstrate that the recommendation is met. Rather, it is intended that any agency proposing to conduct tests to this practice shall be able to demonstrate that if such a single test could be and were carried out, then their equipment would meet the recommendations. This demonstration shall be undertaken on the basis of reasonable deductions from evidence in their possession, such as the results of partial tests.In some systems it may be necessary to divide the whole channel into subsystems, for calibration and checking purposes. The recommendations have been written only for the whole channel, as this is the sole route by which subsystem performances affect the quality of the output. If it is difficult to measure the whole channel performance, which is usually the case, the test agency may treat the channel as two or more convenient subsystems. The whole channel performance could then be demonstrated on the basis of subsystem results, together with a rationale for combining the subsystem results together.Part 1 of this recommended practice covers electronic instrumentation and Part 2 covers photographic instrumentation.

标准名称：	粘胶纤维用竹浆粕
英文名称：	Bamboo pulp board for viscose fiber
中标分类：	纺织 >> 化学纤维 >> 化学纤维半制品
ICS分类：	纺织和皮革技术 >> 纺织纤维 >> 人造纤维
发布部门：	中华人民共和国发展和改革委员会
发布日期：	2006-05-06
实施日期：	2006-10-01
首发日期：	1900-01-01
作废日期：	1900-01-01
提出单位：	中国纺织工业协会
归口单位：	上海市纺织工业技术监督所
起草单位：	河北吉藁化纤有限责任公司
起草人：	郑书华、岳福生、李振峰、范梅欣、薛振军
出版社：	中国标准出版社
出版日期：	1900-01-01
页数：	平装16开， 页数：8， 字数：10千字

本标准规定了粘胶纤维用竹浆粕的术语和定义、要求、试验方法、检验规则、标志、包装、运输和贮存。本标准适用于以竹材为原料，供生产粘胶纤维的竹浆粕的检验、定等和验收。其他类型的粘胶纤维用竹浆粕可参照使用。

没有内容

没有内容

GB/T 1250 极限数值的表示方法和判定方法
FZ/T 50010.1-1998 粘胶纤维用浆粕 取样方法
FZ/T 50010.2-1998 粘胶纤维用浆粕 水分的测定
FZ/T 50010.3-1998 粘胶纤维用浆粕 粘度的测定
FZ/T 50010.4-1998 粘胶纤维用浆粕 甲种纤维素含量的测定
FZ/T 50010.5-1998 粘胶纤维用浆粕 灰分的测定
FZ/T 50010.6-1998 粘胶纤维用浆粕 铁含量的测定
FZ/T 50010.7-1998 粘胶纤维用浆粕 白度的测定
FZ/T 50010.8-1998 粘胶纤维用浆粕 尘埃度的测定
FZ/T 50010.9-1998 粘胶纤维用浆粕 吸碱值和膨润度的测定
FZ/T 50010.10-1998 粘胶纤维用浆粕 定量的测定